OLDE MIDWAY SPIN1400 Instruction Manual
  1. Manuals
  2. Brands
  3. OLDE MIDWAY Manuals
  4. Kitchen Appliances
  5. SPIN1400
  6. Instruction manual

OLDE MIDWAY SPIN1400 Instruction Manual

Hide thumbs
1
2
3
4
5
6
7

Advertisement

Table of Contents

INSTRUCTION
SPIN1400
MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SPIN1400 and is the answer not in the manual?

Questions and answers

Related Manuals for OLDE MIDWAY SPIN1400

Summary of Contents for OLDE MIDWAY SPIN1400

  • Page 1 INSTRUCTION SPIN1400 MANUAL...
  • Page 2 Page 2 WARNING Misuse of this machine may result in serious injury. Please read and follow all precautions below. This machine is not a toy and should not be operated by children. Take proper safety precautions when using this machine. Do not use the machine for other than its intended purpose and do not modify.
  • Page 3 Page 3 FIRST-TIME SET UP PROCEDURE Floss Head Voltage Meter Power Fuse Heat Control Switch Switch 1. Wipe the pan and floss head with a damp clean cloth and dry thoroughly. Do not clean with detergent or abrasive chemicals. 2. Place the cotton candy machine on a flat stable surface. The machine operates at very high speeds making stability essential.
  • Page 4 Page 4 Safety Switch (not shown) Pan Bracket Latch Fig. 1 Fig. 2 4. Carefully, hold the pan on top of the base aligning pan brackets with the four latches. (Fig. 1) 5. Securely latch the pan to the machine by hooking the latch ring over the pan brackets and pressing down on each of the four latches until fully engaged.
  • Page 5 Page 5 OPERATION INSTRUCTIONS 1. Press the power switch ON and allow the machine to run for 1-2 minutes. Note: If the machine begins to vibrate excessively, turn the Power Switch to OFF. Unplug the machine and make sure it’s on a level working surface. 2.
  • Page 6 Page 6 CARE & MAINTENANCE CLEANING After your final batch of cotton candy in a session, keep the machine running and hot while cleaning the floss head by slowly pouring a small amount of water into the center. NOTE: The water will immediately become hot steam. Keep the floss head spinning through until water runs almost clear.
  • Page 7 Page 7 TROUBLESHOOTING MACHINE HAS NO POWER Check to make sure that the bowl is seated correctly and all four latches are engaged and secure. If the safety switch is engaged and both switches are ON, unplug the machine and check the fuse; replace if defective. Contact us for further assistance if this does not resolve the problem.

Table of Contents