Image Alignment - Primera XR User Manual

TOC

Image Alignment

The Image Alignment button will allow you to nudge the
image up, down, left, or right on your disc. To center the
image, click the Image Alignment button. You will be
prompted with a choice to print a test print or simply enter
values to nudge the image alignment on the disc.
If you do not know the direction and distance to move the
image in order to center it on your disc, you can opt to print
the centering test
ink cartridges installed, and it is connected and ready to
receive a print job, and then click the Yes button. The
Publisher will pick a disc and print a scale of numbers on it.
You will be prompted to open the Publisher's
front cover, rotate the printed disc 180 degrees,
reload it into the input, and close the cover.
Click OK when ready and the Publisher will
pick the disc and print another scale of numbers.
The disc should look like this:
Calibrate Last Disc
Use this calibration if you frequently receive false messages
that two discs were picked. Also, use this calibration if the
Publisher will not switch from the right bin to the left bin in
kiosk mode. When you press this button you will be prompted
to place one disc each in both the left and right bins. The
Publisher will then touch each disc with the robotic arm to set
the correct measurement for the last disc in the bin.
Creating Discs on a Mac
46
print. Make sure the Publisher has discs and
5
5
BACK
BACK
4
4
3
3
2
2
1
1
NOTE:
0
0 number)
After printing this image -1 -1
once, rotate this CD -2 -2
number
-3
so the ARROWS point
-3
to the BACK of the printer -4
-4
-5
and print again.
-5
INDEX
SAME the be (must
tough lines whose
the enter and Find
Calibration Vertical
5 4 3 2 1 0 -1 -2 -3 -4 -5
5 4 3 2 1 0 -1 -2 -3 4 -5
number) SAME the be (must
tough lines whose
number the enter and Find
Calibration Horizontal