Husqvarna A 2000 Operator's Manual page 6

b) For A 2000: A>70°.
3. Make sure that the angle is correct.
4. If the angle is not correct, tighten the adjustment
screw (A) to adjust the Toggle fastener.
6
A
B
A
C
5. Push all Toggle fasteners to locked position (C).
6. Make sure that the filter frame is fully closed.
7. Tighten the lock screws (B).
To clean the product
WARNING:
disconnect the power cord from the wall
outlet.
WARNING:
the air when cleaning the product. Use
personal safety equipment, refer to
protective equipment on page 4 .
• Do not clean the product with a high-pressure
washer or compressed air.
• Clean the external surface with a moist cloth.
• Do not use water on electrical components.
• The HEPA filter cannot be cleaned and must be
replaced when full.
• After maintenance, put discarded parts in plastic
bags. Refer to local regulations for the correct
procedure.
• If you use water to clean the product, remove the
prefilter before you clean. Also make sure that no
water goes into the HEPA filter.
Stop the product and
Dust can come out in
Personal
923 - 002 - 11.10.2022