Mounting On A Table - LG 19LS3500-ZA Owner's Manual

y When attaching the stand to the TV
set, place the screen facing down on a
cushioned table or flat surface to protect the
screen from scratches.
y Make sure that the screws are inserted
correctly and fastened securely. (If they are
not fastened securely enough, the TV may
tilt forward after being installed.)
Do not use too much force and over tighten
the screws; otherwise screw may be
se
damaged and not tighten correctly.
y Remove the stand before installing the TV
on a wall mount by performing the stand
attachment in reverse.

Mounting on a table

1 Lift and tilt the TV into its upright position on a
table.
- Leave a 10 cm (minimum) space from the
wall for proper ventilation.
2 Connect the power cord to a wall outlet.
y Do not place the TV near or on sources
of heat, as this may result in fire or other
damage.
CAUTION
NOTE
10 cm
CAUTION
ASSEMBLING AND PREPARING
Securing the TV to a table
(Only 32LS35**, 26/32/42CS46**, 32/42LS34**)
Fix the TV to a table to prevent from tilting forward,
damage, and potential injury.
To secure the TV to a table, insert and tighten the
supplied screw on the rear of the stand.
WARNING
y To prevent TV from falling over, the TV
should be securely attached to the floor/
wall per installation instructions. Tipping,
shaking, or rocking the TV may cause injury.
Adjusting the angle of the TV to suit view
(Only 32/42CS46**, 32/42LS340*)
Swivel 20 degrees to the left or right and adjust the
angle of the TV to suit your view.
20
CAUTION
y When adjusting the angle of the product,
watch out for your fingers.
» Personal injury may occur if hands or fingers
are pinched. If the product is tilted too much, it
may fall, causing damage or injury.
19
20