Trigger Mode; Decode Session Timeout - Newland EM3296 User Manual

Enter Setup

Trigger Mode

If the Trigger Mode is enabled, driving the TRIG pin on the host interface connector low activates a
decode session. The session continues until the barcode is decoded or decode session timeout expires
or the active trigger signal is no longer present. For good read, the engine transmits decoded data via
communication port. To activate another session, the Host needs to first negate the trigger, waits 20ms or
longer and then drive the TRIG pin low.
** Trigger Mode

Decode Session Timeout

This parameter sets the maximum time decode session continues during a scan attempt. It is
programmable in 1ms increments from 0ms to 3,600,000ms. The default setting is 3,000ms. To learn how
to program this parameter, see Appendix 5.
Decode Session Timeout
** Exit Setup 22