Correct Disposal Of This Product - SCAN domestic SFS 350 User Manual

Hide thumbs

Table Of Contents

Table of Contents

Available languages

below. You can carry out some easy checks according to this sec-

tion before calling for service.

Warning! Don't try to repair the appliance yourself. If the prob-

lem persists after you have made the checks mentioned below,

contact a qualified electrician, authorized service engineer or the

shop where you purchased the product.

Appliance is not working correctly

•

Check whether the power cord is plugged into the power

outlet properly.

•

Check whether the "Power" funtion is on by pressing the

"power" button for 1 second.

•

Check the fuse or circuit of your power supply, replace if

necessary.

The ambient temperature is too low.

•

Try setting the chamber temperature to a colder level to

solve this problem.

•

It is normal that the refrigerator is not operating during the

automatic defrost cycle, or for a short time after the appli-

ance is switched on to protect the compressor.

Odours from the compartments

•

The interior may need to be cleaned.

•

Some food, containers or wrapping cause odours.

Noise from the appliance

The sounds below are quite normal:

•

Compressor running noises.

•

Air movement noise from the small fan motor in the fridge

compartment or other compartments.

•

Gurgling sound similar to water boiling.

•

Popping noise during automatic defrosting.

•

Clicking noise before the compressor starts.

Other unusual noises are due to the reasons below and may

need you to check and take action:

•

The cabinet is not level.

•

The back of appliance touches the wall.

•

Bottles or containers fallen or rolling.

The motor runs continuously

It is normal to frequently hear the sound of the motor, it will

need to run more when in following circumstances:

•

Temperature setting is set colder than necessary

•

Large quantity of warm food has recently been stored within

the appliance.

•

The temperature outside the appliance is too high.

•

Doors are kept open too long or too often.

•

After your installing the appliance or it has been switched

off for a long time.

A layer of frost occurs in the compartment

•

Check that the air outlets are not blocked by food and

ensure food is placed within the appliance to allow sufficient

ventilation. Ensure that door is fully closed. To remove the

frost, please refer to cleaning and care chapter.

Temperature inside is too warm

You may have left the doors open too long or too frequently;

or the doors are kept open by some obstacle; or the appliance

is located with insufficient clearance at the sides, back and top.

Temperature inside is too cold

•

Increase the temperature by following the "Display controls"

chapter.

Doors can't be closed easily

Check whether the top of the refrigerator is tilted back by 10-

15mm to allow the doors to self close, or if something inside is

preventing the doors from closing.

Water drips on the floor

•

The water pan (located at the rear bottom of the cabinet)

may not be properly leveled, or the draining spout (located

underneath the top of the compressor depot) may not be

properly positioned to direct water into this pan, or the

water spout is blocked. You may need to pull the refrigerator

away from the wall to check the pan and spout.

Important safety instructions

It is prohibited to dispose of this appliance as household waste.

Packaging materials

Packaging materials with the recycle symbol are recyclable. Dis-

pose of the packaging into a suitable waste collection container

to recycle it.

Before disposal of the appliance

1. Pull out the mains plug from the mains socket.

2. Cut off the power cord and discard with the mains plug.

Warning! Refrigerators contain refrigerant and gases in the insu-

lation. Refrigerant and gases must be disposed of professionally

as they may cause eye injuries or ignition. Ensure that tubing

of the refrigerant circuit is not damage prior to proper disposal.