Installation And Use Restrictions; Standards And Regulations; Set-Up; Conformity Information - Sferalabs SPMB30XP Quick Reference

Installation and use restrictions

Standards and regulations

The design and the setting up of electrical systems must be performed according to the
relevant standards, guidelines, specifications and regulations of the relevant country. The
installation, configuration and programming of the devices must be carried out by trained
personnel.
The installation and wiring of connected devices must be performed according to the
recommendations of the manufacturers (reported on the specific data sheet of the product)
and according to the applicable standards.
All the relevant safety regulations, e.g. accident prevention regulations, law on technical
work equipment, must also be observed.
Safety instructions
Carefully read the safety information section at the beginning of this document.

Set-up

For the first installation of the device proceed according to the following procedure:
✓ make sure all power supplies are disconnected
✓ install and wire the device according to the schematic diagrams on the specific product
user guide
✓ after completing the previous steps, switch on the power supply and other related
circuits.

Conformity Information

EU
This device complies with the following applicable European Community harmonised
standards:
✓ 2014/30/EU - Electromagnetic Compatibility Directive (EMC)
✓ 2011/65/EU and 2015/863/EU - Restriction of the use of certain hazardous substances
in electrical and electronic equipment (RoHS)
The following harmonised standards have been used to demonstrate conformity to these
directives:
✓ EN61000-6-2:2019 - EMC Immunity standard for industrial environments
✓ EN 61000-6-3:2007/A1:2011/AC:2012 - EMC Emission standard for residential,
commercial and light-industrial environments
The declaration of conformity is available at: https://www.sferalabs.cc
Page 6 of 8