Disposal; Installation And Use Restrictions; Standards And Regulations - Sferalabs SPBB21X Quick Reference

Disposal

Waste Electrical & Electronic Equipment
(Applicable in the European Union and other European countries with
separate collection systems). This marking on the product, accessories or
literature indicates that the product should not be disposed of with other
household waste at the end of their working life. To prevent possible harm to
the environment or human health from uncontrolled waste disposal,
separate these items from other types of waste and recycle them
responsibly to promote the sustainable reuse of material resources.
Household users should contact either the retailer where they purchased this product, or
their local government office, for details of where and how they can take these items for
environmentally safe recycling. This product and its electronic accessories should not be
mixed with other commercial wastes for disposal.
Strato Pi Base contains a small non rechargeable manganese dioxide lithium coin battery.
In the Strato Pi Base server, the battery is not accessible from the outside. You should first
remove the case top body to gain access to the Strato Pi Base circuit board. Always
remove the battery before disposing of this product.

Installation and use restrictions

Standards and regulations

The design and the setting up of electrical systems must be performed according to the
relevant standards, guidelines, specifications and regulations of the relevant country. The
installation, configuration and programming of the devices must be carried out by trained
personnel.
The installation and wiring of connected devices must be performed according to the
recommendations of the manufacturers (reported on the specific data sheet of the product)
and according to the applicable standards.
All the relevant safety regulations, e.g. accident prevention regulations, law on technical
work equipment, must also be observed.
Safety instructions
Carefully read the safety information section at the beginning of this document.
Set-up
For the first installation of the device proceed according to the following procedure:
✓ make sure all power supplies are disconnected
✓ install and wire the device according to the schematic diagrams on the specific product
user guide
✓ after completing the previous steps, switch on the power supply and other related
circuits.
Page 6 of 8