Bosch GDS18V-770 Operating/Safety Instructions Manual page 12

Intended Use
bolts, nuts and various threaded fasteners.
This tool is not intended for use as a drill.
Variable Speed Controlled
Trigger Switch
Your tool is equipped with a variable speed
trigger switch. The tool can be turned "ON" or
"OFF" by squeezing or releasing the trigger.
The speed can be adjusted from the minimum
to maximum nameplate RPM by the pressure
you apply to the trigger. Apply more pressure
to increase the speed and release pressure to
decrease speed (Fig. 1).
Brake
When the trigger switch is released it activates
the brake to stop the chuck quickly. This is
especially useful in the repetitive driving and
removal of screws.
Forward/Reversing Lever
and Trigger Lock
prevent accidental starts and accidental
discharge.
Your tool is equipped with a forward/
reversing lever and trigger lock 3 located
above the trigger (Fig. 6). This lever was
designed for changing rotation of the socket,
and for locking the trigger in an "OFF"
position.
To lock the trigger, move the lever to the
center.
For forward rotation, (with chuck pointed
away from you) move the lever to the far left.
For reverse rotation move the lever to the far
right. To activate trigger lock move lever to the
center off position.
comes to a complete stop. Shifting during
rotation of the chuck can cause damage to the
tool.
800.544.2843
Operating Instructions
This tool is intended for the
tightening and loosening of
After tool use, lock trigger
in "OFF" position to help
Do not change direction of
rotation until the tool
www.calcert.com
15
10 20
5 25
0 30
(3)
12
Fig. 6
(3)
sales@calcert.co