Ariens ST11528DLE Owner's/Operator's Manual page 18

Drift Cutters
(Figure 15)
Drift cutters break up snow drifts that are
taller than the auger housing and direct the
snow into the auger. Store the drift cutters on
the auger housing when not in use. Install
them as shown below so they are taller than
the snow to be cleared.
1. Stored Position
2. Operating
Position
Figure 15
Track Angle (926021, 022, 023)
(Figure 16)
The track angle can be adjusted to position
the auger housing for level clearing, deep
cutting or transport.
Depress the Foot Pedal and press down on
the handlebars to move the auger housing
into an up position.
1
2
OS7110
GB - 18
Lift up on the handlebars and tap the Foot
Pedal to move the auger housing into a down
position.
Foot
Pedal
Foot
Pedal
Foot
Pedal
Figure 16
Filling Fuel Tank
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
Fuel Shut-Off Valve
IMPORTANT: The fuel shut-off valve MUST
be in the closed position prior to transporting
the unit.
Normal
Transport
Deep Cutting
OS7111