Ariens ST11528DLE Owner's/Operator's Manual page 16

2. Part-Throttle
3. Slow (cold weather
starts)
4. Stop (engine is off) (Not
on 12V models)
Electric Starter 120V
The electric starter will start a properly
choked and cranked engine when the key is
turned (12V) or starter button (120V) is
pushed. Refer to Starting and Shut Off on
page 20.
Recoil Starter Handle
When pulled, handle will turn engine over.
IMPORTANT: DO NOT let handle snap back
against starter.
Snow Clean-Out Tool
(Figure 12)
WARNING: Hand contact with the
rotating impeller is the most
common cause of injury associated
with snow throwers. Never use
your hand to clean out the
discharge chute.
To clear the discharge chute:
1. Shut off the engine.
2. Wait 10 seconds and make sure impeller
blades have stopped rotating.
3. Remove the snow clean-out tool (1) from
the auger housing and use it to remove
the clog from the discharge chute.
4. Replace the snow clean-out tool on the
auger housing.
1
OS7101
Figure 12
Deflector Remote
Place deflector into position before operation.
DO NOT throw snow any higher than
necessary.
Place deflector remote in a forward notch to
throw snow lower. Place deflector remote in a
rearward notch to throw snow higher.
Discharge Chute
Discharge chute rotates 200°.
ALWAYS position discharge chute in safe
direction and angle, away from operator and
bystanders, before starting engine.
Discharge Chute Control
IMPORTANT: If chute does not stay in set
position, adjust as directed in SERVICE AND
ADJUSTMENTS on page 25, or repair before
operation.
Rotate the Chute with Discharge Chute
Control.
IMPORTANT: DO NOT force frozen chute
controls. If frozen, take to warm place until
controls are free.
Heated Handles
OS1950
GB - 16
Figure 13
Turn the heated handles
1
switch to the ON (1)
position to activate. Turn
the switch to the OFF (2)
position to deactivate.
2
OS7105