Advertisement
Quick Links
ANTMINI
Installation Instructions
UK contact:
Helpline:
+44 (0)1553 811000
Email:
support@maxview.co.uk
Web:
www.maxview.co.uk
Maxview reserve the right to change specifications without prior notice
9111454 Iss 1
Mini 5G/4G 2X2 MIMO Antenna
Maxview Address:
Maxview Ltd, Garage Lane, Setchey, King's Lynn, Norfolk. PE33 0AT. UK
Advertisement
Related Manuals for Maxview ANTMINI
Summary of Contents for Maxview ANTMINI
- Page 1 Mini 5G/4G 2X2 MIMO Antenna ANTMINI Installation Instructions UK contact: Maxview Address: Helpline: +44 (0)1553 811000 Maxview Ltd, Garage Lane, Setchey, King’s Lynn, Norfolk. PE33 0AT. UK Email: support@maxview.co.uk Web: www.maxview.co.uk Maxview reserve the right to change specifications without prior notice 9111454 Iss 1...
-
Page 2: Table Of Contents
Introduction Thank you for purchasing this product, should you have any difficulty using your Antenna please contact our friendly Customer Helpline on +44 (0)1553 811000 or email support@maxview.co.uk. Contents Additional Information Installation Instructions General Safety Warnings Terms and Conditions Positioning your Antenna... - Page 3 Accessories - Sold separately Bracket Fixing Kit - For roof mounting Weatherproof Socket with SMA Connectors The raiser bracket allows you the flexibility to The Weatherproof Socket provides an external entry mount your antenna anywhere on your roof and point into the side of any vehicle. Available with 2 enter the cable at your preferred point using the SMA connections, making it ideal when using the supplied cable entry cover.
-
Page 4: Positioning Your Antenna
Positioning your Antenna Distance between Router and Antenna For best performance, we recommend mounting the router in close proximity to the roof mounted antenna. For best performance, do not use extension cables that are no longer than necessary. Roof Antenna Position We recommend leaving 30cm gap from obstacles around the antenna to avoid interference issues and mounting on a horizontal flat roof. -
Page 5: Fitting The Antenna
Fitting the Antenna Front of vehicle Once you have a suitable position for the antenna, At the marked centre position, drill a 2.5mm pilot cut out the supplied template. Use to mark the 25mm hole through the roof. Use a 25mm hole saw to drill centre hole position and mark the outside of the out the centre hole through the roof. - Page 6 Clean the surface where the antenna will be Pass the cables through the hole and remove the installed, ensuring it is free from debris and grease. self-adhesive backing from the 3M seal. Pass the cables through the roof and position the antenna making sure it’s facing the front of the vehicle - Please reference Picture 7 below.
-
Page 7: General Safety Warnings
Terms and conditions In no event shall Maxview be liable for any indirect, incidental or consequential damages from the sale or use of the product. This disclaimer applies both during and after terms of the guarantee. This does not affect your statutory rights. -
Page 8: Year Guarantee
A guarantee authorisation must be obtained from Maxview prior to work commencing. c) Maxview is responsible for the cost of a replacement part if the original part is determined to be defective under the terms of the guarantee.