Maintenance - Husqvarna 562 XP Operator's Manual

7. Continue to cut more into the tree until the tree/
branch bends and the tension is released.
8. Cut the tree/branch from the opposite side of the
bend, after the tension is released.
To use the product in cold weather
CAUTION: Snow and cold weather can
cause operation problems. Risk of too low
engine temperature or ice on the air filter
and the carburetor.
1. Clothe a part of air intake on the starter. This
increases the engine temperature.
2. For temperatures between 0°C/32°F and -5°C/23°F,
open the plug in the partition wall.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
587 - 002 - 04.12.2019
3. For temperatures below -5°C/23°F or in conditions
with snow, a winter cover is available. Assemble the
winter cover on the starter housing. The winter cover
decreases the flow of cool air and keeps snow away
from the carburetor space.
Note: Part number for winter cover: 522 98 65-02
Heated handles (562 XPG)
The product has heated front and rear handles. The
electrical heating coils are powered by a generator.
Push the switch in the direction of the arrow to engage
the function. Push the switch in the opposite direction to
disengage the function.
Electrical carburetor heating (562 XPG)
Adjustment of the carburetor heating is done electrically
through a thermostat. This keeps the correct carburetor
temperature and prevents ice in the carburetor.

Maintenance

CAUTION: Remove the winter cover if
the temperature increases above -5°C/
23°F. Assemble the plug in the partition
wall if the temperature increases above
0°C/32°F. Risk of too high engine
temperature and damage to the engine.
21