Samsung WD10N6 Series User Manual page 41

Delay End
You can set the washing machine to finish your wash automatically at a later time, choosing
a delay of between 1(60minutes) to 24 hours (in 1 hour increments). The hour displayed
indicates the time the wash will finish.
1. Select a cycle. Then change the cycle settings if necessary.
2. Press Delay End (the +/- button) repeatedly until a desired end time is set.
3. Press and hold Start/Pause. The Delay End indicator blinks and the washing machine
tumbles the drum to sense the weight of the load if load sensing is preset for the selected
cycle. When complete, it displays your set time with the timer running.
4. To cancel the Delay End, restart the washing machine by pressing Power.
Real-life case
If you are going out at 5pm want to make sure the 2 hour wash cycle is completed by this
time, select the Delay End option. Simply select the 3 hour setting and press Start/Pause at
2:00 pm. The washing machine will then start operating at 3:00 pm and will end at 5:00 pm.
Please see below for the diagram which explains the timings of this example.
2:00 pm
Set the Delay End to 3 hours
Load sensor
The load sensor icon lights up when you select a cycle that supports load sensing. Some
cycles may not support loading sensing. Once you start the cycle, the icon blinks or stays
solid during the load sensing process, and turns off when the process is complete.
WD10N641R2X_DC68-04055L_EN.indd 41
3:00 pm
Start
5:00 pm
End
English 41
2020/1/16 15:52:00