Table of Contents
Advertisement
Installation
C
NOTE
• After connecting the water hose to the adaptor, check if it is connected properly by
pulling the water hose downwards.
• Use a popular type of water taps. If the tap is square-shaped or too big, remove the
spacer ring before inserting the tap into the adaptor.
24 English
WD10N641R2X_DC68-04055L_EN.indd 24
C
E
3. Holde the adaptor and turn part (C) in
the arrow direction to loosen it by 5 mm
(*).
4. Insert the adaptor into the water tap,
and tighten the screws while lifting up
the adaptor.
5. Turn part (C) in the arrow direction to
tighten it.
6. While holding down part (E), connect the
water hose to the adaptor. Then, release
part (E). The hose fits into the adaptor
with a clicking sound.
7. To complete connecting the water hose,
see 2 and 3 on the "Connecting to a
threaded water tap" section.
2020/1/16 15:51:55
Advertisement
Table of Contents
