Table of Contents
Advertisement
■ FINGERED
With this chord fingering mode, you play chords on the
accompaniment keyboard using their normal chord fingerings.
Note that some chords can also be formed using abbreviated
fingerings of one or two keys. For information about the types
of chords you can finger and their fingerings, see the
"Fingering
Guide" (page EN-45).
Accompaniment keyboard
● FINGERED 1
Play the component notes of the chord on the keyboard.
● FINGERED 2
Unlike FINGERED 1, 6th input is not possible with this mode.
● FINGERED ON BASS
Play the component notes of the chord on the keyboard. This
mode allows input of fraction chords with the lowest keyboard
note as the base note.
● FINGERED ASSIST
In addition to FINGERED 1 input, you can also use the
fingerings below to play the three chord types.
Minor Chords
One keyboard key for the base note and
(Cm)
the nearest black key to the left.
Seventh Chords
One keyboard key for the base note and
(C7)
the nearest white key to the left.
Minor Seventh
One keyboard key for the base note and
Chords (Cm7)
the nearest black key and white key to
the left.
■ FULL RANGE CHORD
With this chord fingering mode, you can use the full range of
the keyboard to play chords and the melody.
Accompaniment Keyboard/Melody Keyboard
Inserting an Intro or an Ending
Use the procedure below to insert an intro or ending pattern of
a few measures.
1.
In the Rhythm Mode, long-press the ACMP
button.
This momentarily displays "INTRO/ENDING ON" and
then "INTRO>V1" as the current pattern.
• To disable INTRO/ENDING and display "INTRO/
ENDING OFF", long-press the ACMP button again.
2.
To change the pattern, press the PTRN button.
Each press of the PTRN button cycles the setting in the
following sequence: "INTRO>V1", "INTRO>V2", "V1",
"V2".
• "INTRO>V1" and "INTRO>V2" are patterns with intros.
• "V1" and "V2" are short for "VAR1" and "VAR2".
3.
Press a to start rhythm play.
If you selected a pattern with an intro, play starts with the
intro and then the pattern starts to sound after the intro is
complete.
• Instead of pressing a to start rhythm play, you can
also press the ACMP button to display the "AC"
indicator. In this case, playing a chord will start the
intro with the accompaniment.
• To stop an intro and switch to pattern play, press the
PTRN button.
• Note that you cannot select "INTRO>V1" or
"INTRO>V2" while rhythm play is in progress.
4.
At the point where you want to sound the
ending, press a.
This will cause "ENDING" to appear on the display. The
ending will play and then the rhythm will stop.
EN-28
Playing with a Rhythm Backing
Advertisement
Table of Contents
