Table of Contents
Advertisement
4. Connect the supplied power cord
•
The equipment should be installed close to an easily
accessible power outlet.
•
Secure the power cord with the retaining clip.
To prevent the power cord from accidently removing from
the AC IN connector, secure the power cord with the
retaining clip:
1. Lift the retaining clip and plug the power cord into the
AC IN fi rmly (Figure A).
2. Push down the retaining clip over the power cord
(Figure B).
Figure A
•
Please fasten power cord to the LCD monitor by attaching
the screw and clamp.
•
Fully insert the prongs into the power outlet socket.
A loose connection may cause image degradation.
NOTE:
Please refer to the "Safety Precautions and
Maintenance" section of this manual for proper
selection of AC power cord.
Screw
Clamp
NOTE:
If the retaining clip had come off, please attach it
to the bracket again for preventing the power cord
to get loose.
Make sure the retaining clip is the correct position.
Insert the U-shaped end of the retaining clip into
the left side hole fi rstly, then the short end of the
retaining clip into the right side hole.
5. Switch on the power of all the attached
external equipment
When connected with a computer, switch on the power of the
computer fi rst.
6. Operate the attached external equipment
Display the signal from the desired input source.
7. Adjust the sound
Make volume adjustments when required.
8. Adjust the screen (See pages 20 and 21)
Make adjustments of the screen display position when
necessary.
9. Adjust the image (See page 20)
Make adjustments such as backlight or contrast when
required.
10. Recommended Adjustments
Figure B
To reduce the risk of the "Image Persistence", please adjust
the following items based on the application being used:
"SCREEN SAVER", "SIDE BORDER COLOR" (See page 26)
"DATE & TIME", "SCHEDULE SETTINGS" (See page 22).
It is recommended that the "FAN CONTROL" setting
(See page 26) be turned to ON also.
English-13
Advertisement
Table of Contents
