Table of Contents
Advertisement
INSTALLING KNOXCONFIG SOFTWARE (KeySecures with FW v1.8.6 or earlier)
Devices with firmware version 1.8.6 or below must be configured using KnoxConfig. Follow these steps to
download and install the KnoxConfig Software:
1. Before you start the installation, make sure the KeySecure is not connected to the PC via USB.
2. Log into KnoxConnect at
Software.
3. From the left Selection Panel, select Admin.
4. Select the Software tab.
5. From the Software Download list, select Download the KnoxConfig Software.
6. Locate and open the downloaded KnoxConfig Software file.
7. Select the Install button to begin the installation of the KnoxConfig Software and its associated drivers.
8. Follow installation prompts to launch the software.
9. After installation is complete KnoxConfig will automatically run.
KNOX COMPANY | 800-552-5669 | TECHSUPPORT@KNOXBOX.COM |
knoxconnect.net
as the device administrator to download the KnoxConfig
Knox Networking Guide
KNOXBOX.
| OPE-KSCNFG-0292-I | PAGE 20 of 25
COM
Advertisement
Table of Contents
Need help?
Do you have a question about the KeySecure 5 and is the answer not in the manual?