Shutdown - MULTIQUIP GloBug GB113BC Operation And Parts Manual

Figure 17. Hot Lamp Surface
4. Using the mechanical winch (Figure 5, item 2), fully
lower the mast. Turn winch handle counter-clockwise to
lower mast.
5. Using the adjustment lever (Figure 5, item 22) place the
balloon/lamp assembly in the stow position.
6. Unzip the protective cover as shown in Figure 18, and
place cover over balloon/lamp assembly.
Figure 18. Covering the Lamp/Balloon Assembly
7. To unlock outriggers, push downward on the counter-
weight lever indicated by arrow (Figure 19). Grab hold of
outrigger, pull upward, push down and place in stow
position (Figure 20)..
Figure 19. Outriggers (Released)
GB113BC GLOBUG LIGHTING SYSTEM — OPERATION AND PARTS MANUAL — REV. #5 (01/16/12) — PAGE 21
Figure 20. Outriggers (Stow Position)
8. Press down on the top of the brake pedal (Figure 21)
and hold, then release. This action will dis-engage the
brake mechanism and allow the GloBug to be moved.
Figure 21. Parking Brake (Release Position)
Storage
1. Wipe and dir t or foreign matter that may have
accumulated on the GloBug during operation. Use a mild
detergent to clean the unit. DO NOT spray the engine
with water.
2. Avoid storing the GloBug in areas that can be exposed
to rain, harsh elements, and high humidity.
3. Place the GloBug in a clean dry location away from dirt
and debris.

SHUTDOWN