Dsc - Mantracourt DSC User Manual

DSC

Identifying the Gain Resistor position and the Link Track
Reduce Sensitivity
To accommodate a maximum sensor output larger than 2.5 mV/V, it is necessary to reduce the electrical
sensitivity of the input circuitry.
To decrease sensitivity, the link should be cut to take the current gain resistor out of circuit, and the value of the
resistor fitted, in , should be –
Example: For 10mV/V
Increase Sensitivity
When the full-scale output from the bridge is smaller than 2.5 mV/V, it may be desired to increase sensitivity.
To increase sensitivity, the Link Track is left in place, so that the fitted R
temperature stability). Its value should then be-
Mantracourt Electronics Limited
= ( ���������������� ���� �� ⁄ ) × 40
��
��
�� = 10 × 40 = 400 Ω
��
1
�� =
��
0.025
( − 0.01)
⁄
���������������� ���� ��
67
appears in parallel (this gives better
g
DSC/DLC User Manual