Setting Multi Camera To On/Off; Factory System Setup; Setting The Source Category; Setting The Default Vehicle Screen - Alpine INE-W977HD Owner's Manual

Setting Multi Camera to On/Off

When connecting the optional Multi Camera Interface module, you can
connect up to 3 cameras as Front Camera/Rear Camera/Side Camera.
• When using the optional Multi Camera Interface module, select
"Camera Selector" to set the "Front Camera /Rear Camera/Side
Camera" to "On" ( )/"Off " (
Setting item:
Front Camera / Rear Camera / Side Camera / Default Camera*
Setting contents:
Off (Initial setting) / On
Camera See "Setting the Camera Signal Input" (page 47)
Signal:
Guide See "Adjusting the Rear/Front/Side Camera Guide"
Adjustment: (page 47)
Camera See "Camera Interrupt Setting (Power OFF Mode) (Rear
Interrupt Camera Only)" (page 48)
(Power Mode):
* You can change the Default Camera only when you set more than one
camera for Front Camera/Rear Camera/Side Camera to "On. " For
details, see "Setting a Default Camera" (page 49).
Setting a Default Camera
When connecting an optional Multi View Camera, you can set which
camera image is displayed when you touch the Camera button on the
Menu screen or press the (CAMERA) button (X209D only).
Setting item:
Default Camera
Setting contents:
Front / Rear / Side
• The initial setting differs depending on the cameras set to "On" in
"Setting Multi Camera to On/Off. "

Factory System Setup

[Factory System Setup] is selected on the System Setup Menu screen in
step 1. See "System Setup" (page 46).
).

Setting the Source Category

You can set whether the following source icon in the Menu screen is
available.
Setting item:
USB/iPod (Initial setting: Both) / SiriusXM (Initial setting: Aftermarket)
Setting contents:
Both / Factory / Aftermarket
Both*: Both the sources listed above from this unit and
iDataLink module are available.
Factory: Only the source listed above from iDataLink module is
available.
Aftermarket: Only the source listed above from this unit is available.
* USB/iPod only.
• The iDataLink source icons not displayed on the Menu screen when no
iDataLink module is connected even though "Both" or "Factory" is set.
• You cannot set the source that is currently being played.

Setting the Default Vehicle Screen

Press and hold the (Favorite) button for at least 2 seconds or touch
the Menu screen (page 22) to display the Info mode screen, and then set
the following.
Setting item:
Default Vehicle Screen
Setting contents:
Climate / Vehicle Info. / Gauges / Parking Assist / Last mode (Initial setting)
• Depending on the car, some setting contents or this setting item may not
be displayed.

Setting the Maestro Module

You can change the setting of the connected iDataLink module.
Setting item:
Maestro Module
• Depending on the iDataLink module, the setting contents may differ.
49
-EN