Dometic COOLAIR SPX1200IC Operating Manual page 21

RTX2000, SPX1200IC
8.2 Control panel fault messages
The "ERROR" symbol (fig. 4 5, page 11) lights up if there is a fault with the parking
cooler. The type of error is shown on the display by the following error codes:
Display
Description
text
F01 The compressor does
not work.
F02
F03
F04 The condensor fan 1
does not work.
F05 The condensor fan 1 is
overloaded.
F06 The condensor fan 2
does not work.
F07 The condensor fan 2 is
overloaded.
F08 The evaporator fan does
not work.
F09 The evaporator fan is
overloaded.
F10 The condensation water
that has formed is not
being discharged.
F11 The system cannot
determine the internal
temperature.
F12
EN
Cause
Error in compressor
sensor electrical supply
(open circuit).
Error in compressor
sensor electrical supply
(short circuit).
Compressor overload
No response from the
fan.
Faulty fan speed
No response from the
fan.
Faulty fan speed
No response from the
fan.
Faulty fan speed
The condensation water
that has formed is not
being discharged.
Error in temperature
sensor electrical supply
(open circuit).
Error in temperature
sensor electrical supply
(short circuit).
Display messages
Remedy
➤ Switch off the system.
➤ Switch it on again after
30 minutes.
➤ If the fault occurs again,
contact an authorized
workshop.
21