Dometic COOLAIR SPX1200IC Operating Manual page 14

Using the parking cooler
➤ With the system switched off, press the
✔ The fan starts.
✔ The Power LED (fig. 2 7, page 9) lights up.
✔ The digital display (fig. 2 1, page 9) shows the current status of the parking
cooler (see chapter "Display" on page 11).
I
NOTE
Depending on the system status, the system compressor is switched on
with a delay of up to 180 seconds.
7.3 Switching the parking cooler to standby mode
➤ Press the
button briefly to switch the parking cooler to standby mode.
✔ The parking cooler saves the current settings.
✔ The Power LED (fig. 2 7, page 9) continues to light up.
I
NOTE
• When the parking cooler is in BOOST mode and switched to
standby mode, it will start the next time in AUTO mode.
• A running timer is set to 0 by switching the parking cooler in standby
mode.
• The parking cooler switches off completely after 12 hours in standby
mode to save power.
7.4 Switching off the parking cooler
➤ Press the
button for at least 3 seconds to switch off parking cooler.
✔ The parking cooler saves the current settings.
✔ The Power LED (fig. 2 7, page 9) goes out.
I
NOTE
• When the parking cooler is in BOOST mode and switched off, it will
start the next time in AUTO mode.
• A running timer is set to 0 by switching off the parking cooler.
• If the parking cooler is switched off while the compressor is still
operating, the fan will continue to run for 20 seconds to dry the
evaporator, among other things.
14
RTX2000, SPX1200IC
button.
EN