Installation Procedure; Installing With Microwave Or Steam Oven; Pre-Assembly Preparation; Mounting The Microwave On The Warming Drawer - Bosch HWD50 Installation Manual

Installation Procedure

9 CAUTION
Before installing, turn power OFF at the service
panel. Lock service panel to prevent power from
being turned ON accidentally.
Installing with Microwave or Steam
Oven

Pre-Assembly Preparation

Mounting the microwave or steam oven on the warming
drawer requires the units to be assembled together prior to
installing into the cabinet cutout.
Note:
The parts contained in the square tube parts box are
common to both installations.
Parts Provided
Universal connector
bracket (2)
(in parts box)
Screws (12)
(in red bag, inside parts
box)
1. Prepare cabinet cutout.
Prepare cabinet cutout and install electrical connection
according to the dimensions in "General Information".
2. Remove the drawer from the drawer housing.
a. Pull drawer to fully open position.
b. Press down right drawer release lever.
c. Lift up left drawer release lever.
d. Firmly pull the drawer straight out.
Retract cabinet rails while drawer is removed.
English 4
3. Position the warming drawer housing in front of the
cabinet where it is to be installed. Position the
Microwave or Steam Oven nearby.
4. The warming drawer is ready for the Microwave or
Steam oven to be mounted on it.
Mounting the Microwave on the Warming
Drawer
Assemble the Brackets to the Warming Drawer
Note: Do not place the warming drawer into the wall
cabinet until after mounting the microwave on it using the
universal connector brackets.
1. Attach both universal connector brackets to the
warming drawer housing using three of the screws
provided for each bracket. Tighten screws securely,
but do not overtighten.
Note: The universal connector brackets are interchange-
able for the left and right sides of the warming drawer. Be
sure the taller vertical edge of the bracket is positioned to
the outside of the warming drawer.