Table of Contents
Advertisement
Wall Mounting the TZ Appliance
WARNING:
Do not mount the appliance on the ceiling, it is not designed for secure ceiling
mounting.
For optional wall mounting, you need:
• Screwdriver
• Drill with appropriate size bit
• For mounting on drywall:
• Two #6 pan-head screws, 1 inch long (7mm diameter head, 25 mm long)
• Two wall anchors
• For mounting on solid wood or metal:
• Two #6 pan-head wood or machine screws, 1 inch long (7mm diameter head, 25 mm long)
To mount the appliance on the wall:
1
Depending on your TZ model, do one of the following:
a For TZ300P – Drill two holes 4.5 inches (11.5 cm) apart where you want to mount the appliance.
b For TZ600P – Drill two holes 6.2 inches (15.8 cm) apart where you want to mount the appliance.
2
If using wall anchors, insert a wall anchor into each hole.
3
Insert a screw into each wall anchor (into each hole if not using wall anchors), leaving 3/16 inches (0.45
cm) of the screws exposed (including screw head).
4
Position the appliance mounting slots over the screws and press in and down until the appliance is
securely mounted.
Safety and Regulatory Information
WARNING:
For your safety, follow all instructions listed in this section.
Installing the Appliance
1
Install in a location away from direct sunlight and sources of heat. A maximum ambient temperature of 104° F (40° C)
is recommended.
2
Route cables away from power lines, fluorescent lighting fixtures, and sources of noise such as radios, transmitters,
and broadband amplifiers.
The included power cord(s) are approved for use only in specific countries or regions. Before using a power cord,
3
verify that it is rated and approved for use in your location.
Ensure that no water or excessive moisture can enter the unit.
4
5
Allow unrestricted airflow around the unit and through the vents on the side of the unit. A minimum of 1 inch
(25.44mm) clearance is recommended.
6
Consideration must be given to the connection of the equipment to the supply circuit. Appropriate consideration of
equipment nameplate ratings must be used when addressing this concern. Do not overload the circuit.
SonicWall TZ300P/TZ600P
Safety and Regulatory Reference Guide
2
Advertisement
Table of Contents
