Travis Industries Fire Garden 94900432 Manual page 18

18

Connect the gas flex from the key valve (preinstalled
on the inside of the enclosure) to the incoming gas
supply line.

Connect the Gas flex from the burner assembly to
the pre-installed key valve.
NOTE: Leak test all joints before putting the firepit into
service.
With the 108X24 fire pit only, the installer must install the gas "tee" fitting as well as the flex from the tee to the key
valve (see illustration below). The tee and flex are included and shipped in the applinace hardware pack. Make
sure to leak test these connections.

Route the wires from the 24VAC transformer up through the opening in
the enclosure and through the strain relief on the bottom of the electrical
junction box (below the igniter). Use listed low voltage wiring. Make sure
to provide slack in the wire for removal and service. Use wire nuts to
connect the low voltage wires to the white and yellow/white striped wires
from the control module.
© Travis Industries, Inc.
Installation
108x24 Fire Pit ONLY
(qualified installers only)
6/14/23 - 1579 Outdoor Complete Linear Fire Pits