Travis Industries Fire Garden 94900432 Manual page 17

Installation

There are (4) screws that secure the burner tray to the enclosure (see pictures below). Use a 1/4" driver to
remove the screws. Set the screws aside for reinstallation.

Grab the burner assembly by the media trays
on either end. Lift the burner assembly out of
the enclosure.

Set the firepit enclosure over the incoming gas supply and low voltage electrical supply wires from the
required 24v transformer.

Spread a blanket or cardboard over the top of
the enclosure to protect the powder coat finish
and rest the burner assembly on the blanket
diagonally over the opening of the enclosure
that you lifted it out of.
•
Cut the zip ties that secure the coiled up gas flex
line on the burner tray assembly and the coiled up
flex line attached to the key valve on the firepit
enclosure.
© Travis Industries, Inc.
(qualified installers only)
5/15/23 - 1579 Outdoor Complete Linear Fire Pits
17