Light source
9
Replacing the light source
for low-beam and/or high-
112
beam headlight
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Switch off the ignition.
z
Remove cover 1 for the high-
beam headlight or cover 2 for
the low-beam headlight as ap-
plicable, by pulling lever 3.
NOTICE
The positions of the plug, the
spring wire retainer and the
bulb might not be as illustrated
below.
Disconnect plug connection 1.
Disengage spring wire clips 1
from the fastenings and swing
them aside.
Remove bulb 2.
Replace the defective bulb.
Bulb for high-beam
headlight
H7 / 12 V / 55 W
Bulbs for the low-beam
headlight
H7 / 12 V / 55 W