Scotsman TCL 180 Service Manual page 9

Page 9
To modify the original setting time (5 seconds):
a) Push and old the 4
NUOUS" for 10 seconds till the first 3 lights start
to blink
st
b) Push the 1 switch (ICE) for 5 seconds
Push the 2 nd switch (ICE+WATER) for 10 seconds
st
Push the 3 switch (WATER) for 1.5 seconds
th
Push the 4 switch (CONTINUOUS) for 3 seconds
Setting of resume mode (default)
To modify the original resume mode (ICE) push
for 5 seconds the desired switch ICE,
ICE+WATER or WATER.
Dispensing Time and mode EVO Version
This a touch free dispensing model, with only ICE
configuration and no push button in the front
panel.
Dispensing time is factory set at 3" not adjustable
once a glass or a carafe is placed in front of the
two Optical Dispensing Devices.
H. CHECK OF THE DISPENSING
OPERATING MECHANISM
Electronic Version
There are two different versions of dispensing
label; one with just ICE and CONTINUOUS push
th switch "CONTI-
buttons and a second with ICE/WATER +
ICE/WATER and CONTINUOUS push buttons.
To check for the correct operation of the
dispensing mechanism:
a) Select first the Dispensing Mode by
pushing the proper switch;
b) Place a glass or a carafe in front of the two
Optical Dispensing Devices.
c) The dispensing drive motor and/or the
water solenoid valve starts to operate with ice
and/or water discharged through the bottom
plastic spout.
The drive motor and/or the water solenoid valve
remains in operation as per setting dispensing
time unless the glass or carafe is removed.
Push the CONTINUOUS switch and check again
for the dispensing mechanism operation as per
steps above.
The drive motor and/or the water solenoid valve
now remains in operation till the glass or carafe
is removed.
EVO Version
a) Place a glass or a carafe in front of the two
Optical Dispensing Devices.
b) The dispensing drive motor starts to operate
with ice discharged through the bottom plastic
spout.
The drive motor remains in operation as per
factory set dispensing time 3" not adjustable.
I. If previously installed, remove the refrigerant
service gauges and re-fit the unit service panels
previously removed.
J. Instruct the owner/user on the general
operation of the ice machine and about the
cleaning and care it requires.
Page 9