Page 1
49500 & 49600 Art No. 49700 Thank you for purchasing this HiB product. Please read through these instructions carefully and refer back to them during installation to ensure that your product is fitted safely and that it retains its high quality finish.
Page 2
Please Note You may need to remove the door(s) to aid installation. This can be done by unclipping the hinges. (There is a release catch at the back of the hinge see fig.A). Once detached, gently extract the wire between the carcass and the top of the door then disconnect the cable connector(s) (fig.B).
Page 3
Sensor switch controller the cabinet LED driver Rewire the cabinet as shown in the diagram above. HiB recommends that all electrical bathroom products should only be fitted by a suitably qualified, Part P registered electrician. Move door(s) left/right For further assistance on isolating the sensor please contact us.
Need help?
Do you have a question about the Edge 50 and is the answer not in the manual?
Questions and answers