Remove the system board
Make sure the following FRUs (or CRUs) have been removed.
"Remove the LCD module" on page 28
"Remove the battery pack" on page 32
"Remove the system board bracket" on page 34
"Remove the heat sink" on page 35
"Remove the fan" on page 36
"Remove the solid-state drive and foil" on page 38
"Remove the D-Mic cable" on page 44
"Remove the antenna rubbers and microphone rubbers" on page 42
"Remove the front camera and sponge" on page 47
"Remove the rear camera and sponge" on page 49
Step 1.
Disconnect cables connected to the system board.
Figure 38. Disconnect cables
Step 2.
Remove five screws and then remove the system board.
.
Chapter 4
Removing a FRU or CRU
51