GE Profile PTD60EBPRDG Owner's Manual page 10

Table of Contents

Advertisement

Available languages

Available languages

Using the dryer
Fabric Refresh
P
Available for all cycles. When the Fabric Refresh button is pressed, the cycle settings will change to dispense
a dose of fragrance into your dryer to give a fresh scent to your clothes.
There are 3 levels: Auto, More and Less. Each level is intended to give an appropriate dose of fragrance
according to the amount of clothes placed inside the dryer. Press the Fabric Refresh button to switch between
Less, Auto, More or off.
Auto: Recommended to use with average load sizes to provide a light fresh scent.
More: Recommended to use with large load sizes to provide a more intense scent.
Less: Recommended to use with small loads or fewer garments to give a soft scent.
NOTES:
• Dosing will depend on the cycle selected.
• Dosing may change on the same cycle due to temperature and load size.
• Dosing may be adjusted to provide more or less of the fresh scent liquid.
Filling the Fabric Refresh Tank
This Scent Delivery System is approved to be used with the following liquids:
• Downy Wrinkle Releaser
®
• Bounce
In-Dryer Liquid Fabric Refresh
WARNING
The use of any liquid or substance with the Fabric Refresh System, other than those listed above, is strictly
prohibited and may result in a risk of fire, explosion, electric shock, hazardous fumes, or injury to persons.
Doing so may also damage your dryer and void your Warranty.
The Fabric Refresh System is located on the inside of the dryer door and has a dedicated tank for the approved liquids.
To fill the tank:
1
Press the button to release the Fabric Refresh door,
and then pull it down to open.
NOTE: The tank may be filled in place or it may be
removed by grasping its handle and pulling it out.
2
Release the tank cap by turning it counter-clockwise
and lift it up to remove.
10
(on some models)
®
– Light Fresh
3
Pour the liquid fragrance into the tank. Make sure to
not exceed the fill level indicated inside the tank.
4
Replace the tank cap and turn it clockwise making
sure the indents align.
5
If removed, replace the tank into its compartment in
the door making sure it is firmly seated. Close the
Fabric Refresh door.
49-3000244 Rev 7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents