LG WTP22WY Owner's Manual page 38

TROUBLESHOOTING
38
Symptoms
Appliance is not filling
properly.
Appliance does not
drain water.
Cycle time is longer
than usual.
Cycle end is delayed
Performance
Symptoms
Poor stain removal
Inlet filter clogged.
• Make sure the inlet filters on the fill valves are not clogged.
Inlet hoses may be kinked.
• Check that inlet hoses are not kinked or clogged.
Insufficient water supply.
• Make sure that both hot and cold water taps are turned on all the way.
The door and drawer are open.
• The Mini Washer will not operate if the lid is open. Close the lid and make
sure that nothing is caught under the lid preventing it from closing
completely.
Water level in the tub appears to be too low.
• The fill level is optimized for the wash motion to achieve the best wash
results.
Drain hose is kinked, pinched, or clogged.
• Make sure the drain hose is free of blockages, kinks, etc., and is not
pinched behind or under the washing machine.
The load is too small.
• Add more items to allow the appliance to balance the loads.
Heavy articles are mixed with lighter items.
• Always try to wash articles with similar weight in order to allow the
appliance to evenly distribute the weight of the load for spinning.
The load is out of balance.
• Manually redistribute the load if articles have become tangled.
Unbalance is detected or suds removing programme is on.
• This is normal. The time remaining shown on the display is only an
estimated duration. Actual time may vary.
Heavily soiled clothes
• Use Main Washer
Previously set stains.
• Articles that have been previously washed may have stains which have
been set. These stains may be difficult to remove and may require hand
washing or pre-treating to aid in stain removal.
Possible Cause & Solution
Possible Cause & Solution