Asus P11C-M/10G-2T Manual page 89

Setup Prompt Timeout [1]
Allows you to set the number of seconds that the firmware waits before initiating the original
default boot selection. 65535(OxFFFF) means indefinite waiting. Use the <+> or <-> to adjust
the value.
Bootup NumLock State [On]
Allows you to select the power-on state for the NumLock.
Configuration options: [Off] [On]
Quiet Boot [Disabled]
Allows you to enable or disable Quiet Boot option.
Configuration options: [Disabled] [Enabled]
Boot Option Priorities
These items specify the boot device priority sequence from the available devices. The
number of device items that appears on the screen depends on the number of devices
installed in the system.
• To select the boot device during system startup, press <F8> when ASUS Logo
appears.
• To access Windows OS in Safe Mode, please press <F8> after POST.
Fast Boot [Disabled]
Allows you to enable or disable boot with initialization of a minimal set of devices required to
launch active boot option. This has no effect for BBS boot options.
Configuration options: [Disabled] [Enabled]
The following item appears only when you set Fast Boot to [Enabled].
Sata Support [All Sata Devices]
[Last Boot HDD Only] Only last booted HDD device will be available in POST.
[All Sata Devices]
VGA Support [EFI Driver]
[Auto]
[EFI Driver]
USB Support [Full Initial]
[Disabled]
[Partial Initial]
[Full Initial]
PS2 Devices Support [Enabled]
If this option is disabled, PS2 devices will be skipped.
Configuration options: [Disabled] [Enabled]
ASUS P11C-M/10G-2T
All SATA devices will be available in OS and POST.
O nly legacy OpRom with Legacy OS, and logo will NOT be shown
during POST.
Efi driver will still be installed with EFI OS.
All USB devices will NOT be available until after OS boot.
U SB Mass Storage and specific USB port/device will NOT be
available before OS boot.
All USB devices will be available in OS and POST.
4-33