Regulatory Compliance - Clarity Professional C4205 User Manual

REGULATORY COMPLIANCE

Part 68 of FCC Rules Information
a) This equipment complies with Part 68 of the
FCC rules and the requirements adopted by the
ACTA. On the bottom of this equipment is a label
that contains, among other information, a product
identifier in the format US:AAAEQ##TXXXX. If
requested, this number must be provided to the
telephone company.
b) A plug and jack used to connect this equip-
ment to the premises wiring and telephone net-
work must comply with the applicable FCC Part
68 rules and requirements adopted by the ACTA.
A compliant telephone cord and modular plug,
RJ11C USOC, is provided with this product. It is
designed to be connected to a compatible modu-
lar jack that is also compliant. See installation
instructions for details.
c) The REN is used to determine the number of
devices that may be connected to a telephone
line. Excessive RENs on a telephone line may
result in the devices not ringing in response to
an incoming call. In most but not all areas, the
sum of RENs should not exceed five (5.0). To
be certain of the number of devices that may be
connected to a line, as determined by the total
RENs, contact the local telephone company. For
products approved after July 23, 2001, the REN
for this product is part of the product identifier
that has the format US:AAAEQ##TXXXX.
The digits represented by ## are the REN without
a decimal point (e.g., 03 is a REN of 0.3). For
earlier products, the REN is separately shown on
the label.
d) If this telephone equipment causes harm to
the telephone network, the telephone company
will notify you in advance that temporary
discontinuance of service may be required. But
if advance notice isn't practical, the telephone
28