Adjusting Fit; Multi-Shift Pairing; Making/Answering/Ending Calls - Plantronics SupraPlus User Manual

ADJUSTING FIT

1. Adjust headband to fit.
2. Rotate voice tube or noise-canceling microphone until it is pointed towards your chin.

MULTI-SHIFT PAIRING

1
Enable
Disable
1. To pair another headset to the same base, you must first enable the multi-shift
pairing feature. Long press (5 sec.) the speaking volume minor adjust
back of base until the power indicator light flashes.
2. Place a charged headset in charging cradle and red indicator light on base will flash
for 2 seconds if the multi-shift pairing feature is enabled. Within 10 seconds of doing
so, press either the "+" or "-" listening volume button for 3 seconds until
the headset talk indicator lights to indicate pairing mode, and goes out after
successful pairing. Repeat steps 1 and 2 if headset and base do not link when call
control button is pressed.
NOTE: Only the last paired headset will work with the base. You must NOT be in talk mode (i.e.
on a call) to enable or disable this feature.
To disable the multi-shift pairing feature, long press (5 sec.) the speaking volume minor
adjust down button until the power indicator light flashes.
10
NOTE: Depending on preference, you
can replace the pre-installed
leatherette ear cushions with the
alternative foam cushions included.
2
OR OR OR
up button on

MAKING/ANSWERING/ENDING CALLS

Without Handset lifter
To make a call:
1. Take your handset off-hook. Dial tone should sound through handset (if not, check
compatibility—see page 13).
2. Press the call control button on the headset. The talk indicator lights on both the
base and the headset should go on, indicating a successful link. Dial tone should
sound through headset. Dial using the telephone keypad.
To answer a call:
1. Take the handset off-hook.
2. Press the call control button on the headset to answer a call.
To end a call, press the call control button on the headset, then hang up the handset.
NOTE: If either you or the recipient have trouble hearing, please check compatibility (page 13).
11