Baroness FS900 Owner's Operating Manual page 47

Specified Hydraulic Oil
ISO Viscosity Grade
Density 15 °C (59 °F)
API Gravity
Flash Point (Open Cup)
Pour Point
40 °C (104 °F)
Kinematic
Viscosity
100 °C (212 °F)
Viscosity Index
1. Remove the knobs, and then open the front
cover.
2
Hydraulic Oil Supply_001
1 Knobs
2 Front cover
2. Remove the bolts, and then open the cover.
2
Hydraulic Oil Supply_002
1 Bolt
2 Cover
3. If the hydraulic oil level is low, follow the
steps below to supply oil.
[1] Open the tank cap, and then supply
hydraulic oil through the oil filling port
until the oil level reaches the middle of
the oil gauge on the hydraulic tank.
Inspection and Cleaning
Shell Tellus S2M46
ISO VG46
0.873 g/cm 3
3
(0.0315 lb/in )
30.6
230 °C (446 °F)
-30 °C (-22 °F)
46 mm 2 /s (46 cSt)
2
7 mm /s (7 cSt)
109
2
1
dmhzyz-001
1
dmhzyz-002
Handling Instructions
[2] Tighten the tank cap securely.
Hydraulic Oil Supply_003
1 Tank cap
4. Start the engine, raise and lower the brush
frame and the bucket, and then drive the
machine forward and in reverse repeatedly
several times.
5. On a level surface, lower the brush frame
and the bucket and maintain that position,
and then check to see if the oil level is at
the middle of the oil gauge. If necessary,
supply oil.
6. Check underneath the machine for oil
leakage.
7. Install the cover.
8. Close the front cover.
FS900
1
dmhzyz-003
Page 5-7