Little Giant SELECT Series Owner's Manual page 6

WIRING
W A R N I N G
s
WARNING
!
building codes before installation. The installation must be in
accordance with their regulations as well as the most recent
National Electrical Code (NEC).
Check the pump label for proper voltage required. Do not connect
to voltage other than that shown.
A ground fault circuit interrupter (GFCI) is required.
The pump should be connected or wired to its own circuit, with
no other outlets or equipment in the circuit line. The fuses and
circuit breaker should be of ample capacity in the electrical circuit.
See table below:
Pump HP
LG-S50T 1/2
s
WARNING
!
mounted to the pump must not be modified in any way, with the
exception of shortening the cord to fit into a control panel. Any splice
between the pump and the control panel must be made within a
junction box mounted outside of the basin and comply with
the National Electrical Code. Employ a licensed electrician.
s
WARNING
!
Do not use the power cord for lifting the pump.
6
W A R N I N G
Check local electrical and
Voltage Breaker Amps
115 15
The flexible jacketed cord assembly
SPECIFICATIONS
Discharge Size
Intake Size
Pump Housing
Volute
Impeller
Single-phase permanent split capacitor with
Motor
automatic reset thermal overload protection
Hardware
Bearings
Pump Shaft Seal Stationary carbon with Nitrile boot and rotating ceramic seat
Power Cord 16 AWG 3-conductor, copper, stranded, 10' length
The motor housing contains oil to cool the motor and to
lubricate bearings and seals. These pumps are capable of
operating with the motor housing partially exposed for
Cooling
extended periods, providing sufficient motor cooling and
bearing lubrication. However, for the best cooling and
longest motor life, the liquid level being pumped should
normally be above the top of the cast iron motor housing.
Electrical Diagrams
1-1/2" FNPT vertical
3/8" opening
Cast Iron
Cast Iron
Cast Iron
Stainless steel
Ball, top and bottom