Lubricating Control Shafts - Ikelite 200DLM/A Manual

To prevent build-up of salt, sand, or debris, the push buttons
»
should be flushed with fresh, clean water after every use.
Depress each push button while the housing is submerged in
fresh water.
If it is necessary to remove a housing push button, NEVER
»
re-use the e-clip. Push button o-ring kits include replacement
e-clips.
Push buttons look similar but vary in length. Remove and re-
»
install one push button at a time.

Lubricating Control Shafts

1. Loosen the knob set screw using a hex key.
2. Remove the control shaft from the inside of the housing.
3. Clean and lightly lubricate the shaft, including the large outer end
of the shaft.
4. If there is a spring associated with the control, make sure it is in its
proper position.
Control
shaft
24
Housing
Control
flat
Control
gland
Knob
set
screw