Planar DOME Md4/PCI Installation Manual page 144

128
To enable VGA mode, slide the DIP switches into these
positions.
DIP Switch
To disable VGA mode
If you are using another board to support VGA, you must
disable VGA mode on the Md4/PCI board. You must also
install a Digital board in a 64-bit slot to serve as the VGA
console. See "Using the DOME board with an existing
VGA board" on page 127 for more information.
The Digital UNIX workstation supports VGA only in
the 64-bit slots. See "Limitations with VGA support" on
page 134 for more information.
To disable VGA, slide the DIP switches on the Md4/PCI
board into these positions.
DIP Switch
DIP Switch Settings
on Switch S1 to
Enable VGA Mode
Position
1 ON (closed)
2 OFF (open)
3 OFF (open)
4 ON (closed)
DIP Switch Settings
on Switch S1 to
Disable VGA Mode
Position
1 OFF (open)
2 ON (closed)
3 OFF (open)
4 ON (closed)
Chapter 4