Changing The Auto Set Options - Fluke ScopeMeter 190 II Series 190-104 User Manual

Fluke 190-104, Fluke 190-204
Users Manual

Changing the Auto Set Options

With the next procedure you can choose how auto set
behaves when you press the
1 Display the
USER
2 Open the
F1
3 Open the
ENTER
If the frequency range is set to > 15 Hz, the Connect-and-
View function responds more quickly. The response is
quicker because the test tool is instructed not to analyze
low frequency signal components. However, when you
measure frequencies lower than 15 Hz, the test tool must
be instructed to analyze low frequency components for
automatic triggering:
86
- (auto set) key.
AUTO MANUAL
key labels.
USER
menu.
USER OPTIONS
menu.
AUTO SET ADJUST
4 Select 1 Hz and up, then jump to
Input Coupling:
ENTER
When you press the -
AUTO
coupling can either be set to dc or left unchanged:
5 Select Unchanged.
ENTER
When you press the -
AUTO
capture can either be set to On or left unchanged:
6 Select Unchanged.
ENTER
The auto set option for the signal frequency is
similar to the automatic trigger option for the
signal frequency. (See Chapter 4: "Automatic
Trigger Options"). However, the auto set option
determines the behavior of the auto set function
and shows only effect when you press the auto
set key.
(auto set) key, the input
MANUAL
(auto set) key glitch
MANUAL
Note