Yamaha YFM700R Owner's Manual page 104

10. Install the crankcase engine oil drain bolt, the
engine oil tank drain bolt and their new gas-
ket, and then tighten the bolts to the specified
torques.
Tightening torques:
Crankcase engine oil drain bolt:
23 N·m (2.3 kgf·m, 17 lb·ft)
Engine oil tank drain bolt:
19 N·m (1.9 kgf·m, 14 lb·ft)
11. Install the crankcase engine oil filler bolt and
its new O-ring, and then tighten the oil filler
bolt to the specified torque.
Tightening torque:
Crankcase engine oil filler bolt:
12 N·m (1.2 kgf·m, 8.9 lb·ft)
9
12. Pour only 1.3 L (1.37 US qt, 1.14 Imp.qt) of
the specified amount of the recommended
engine oil through the engine oil tank filler
hole, and then install and tighten the oil tank
filler cap.
13. Start the engine, rev it several times, and then
turn it off.
14. Remove the engine oil tank filler cap, and
then gradually fill the oil tank with the remain-
ing oil quantity while regularly checking the oil
level on the dipstick.
15. Check the O-ring for damage, and replace it
if necessary.
16. Install and tighten the engine oil tank filler
cap.
Recommended oil:
See page 11-1.
Oil quantity:
Without oil filter element replacement:
1.75 L (1.85 US qt, 1.54 Imp.qt)
With oil filter element replacement:
1.85 L (1.96 US qt, 1.63 Imp.qt)
TIP
Be sure to wipe off spilled oil on any parts after the
engine and exhaust system have cooled down.
ECB00301
NOTICE
 In order to prevent clutch slippage (since the
engine oil also lubricates the clutch), do not
mix any chemical additives. Do not use oils
9-17