Setup - Bauer 22202E-B Owner's Manual & Safety Instructions

Setup - Before use
read the EntirE iMpOrtant SaFEty inFOrMatiOn section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
tO prEVEnt SEriOuS inJury FrOM acciDEntaL OpEratiOn:
turn the power Switch of the tool off before performing any procedure in this section.
note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
assembly/Mounting
1. Line up the bolt holes in the Wheel (3) and the
Front Leg (4), slide Hex Bolt (1) through the
Wheel Bushing (2), Wheel, and Front Leg.
2. Slide a Flat Washer (28), and Spring Washer (29)
onto the threaded end of the Bolt and secure tightly
with Nut (30).
Repeat with other Wheel.
3. Slide the Support Frame (5) onto the Rear Leg (24).
Line up the bolt holes, slide Hex Bolt (22) through
Bent Washer (23), then through the bolt holes.
Hex
Bolt (1)
Wheel
Bushing (2) Flat Washer (28)
6. Slide Pivot Bracket (8) onto the Leg
Assembly and line up the bolt holes.
7. Slide Hex Bolt (7) through Bent Washer (6)
and bolt holes, slide Bent Washer onto
threaded bolt end and secure with
Locknut (15). Repeat with remaining bolt.
Page 8
FOR CEMENT AND MORTAR ONLY.
Do not use with Epoxy 2-part resin mix.
Support Frame (5)
Front Leg (4)
Wheel (3)
nut (30)
Spring Washer (29)
For technical questions, please call 1-888-866-5797.
NOTICE
4. Slide an Bent Washer onto the threaded end
of the Bolt and secure tightly with Locknut
(25). Repeat with remaining bolt.
5. Line up the mounting plate bolt holes on the
Front Leg Assembly to the Rear Leg Assembly, slide
Hex Bolt (27) through Spring Washer (26), screw
into Front Leg mounting plate and secure tightly.
Hex Bolt (22)
Bent Washer (23)
Locknut (25)
Hex Bolt (27)
Spring
Washer (26)
pivot
Bracket (8)
Hex Bolt (7)
Bent Washer (6)
rear Leg (24)
Locknut (15)
Item 58991