Bauer 22202E-B Owner's Manual & Safety Instructions page 11

General Operating instructions
WarninG! tO prEVEnt SEriOuS inJury:
Do not operate the Mixer on slopes or uneven
surfaces with an incline greater than 5º. Ensure the
Mixer is stable before and after starting the Motor.
WarninG! tO prEVEnt SEriOuS inJury:
Do not attempt to move the Mixer when it
is full and/or in operation. Block the wheels
with wheel chocks (not included).
WarninG! tO prEVEnt SEriOuS inJury: Keep
clear of rollers and other pinch points when running the
Mixer, pivoting, or changing the angle of the Drum.
1. Place the Cement Mixer on a solid, even surface.
2. Connect the Power Cord to an electric
outlet (or properly rated grounded
three prong extension cord).
note: Turn the Motor on before filling the Drum, this
will protect the Motor and evenly mix materials.
3. Press the green "ON" (I) Button, the drum will spin.
note: Inspect the mix frequently to ensure it does
not harden or dry. Allowing mix to harden or dry
could damage the mixer or cause a malfunction.
Item 58991
NOTICE
FOR CEMENT AND MORTAR ONLY.
Do not use with Epoxy 2-part resin mix.
For technical questions, please call 1-888-866-5797.
4. Add material to the Drum. Typical maximum
quantities include: 2 80lb bags of cement
mix and up to 2 gallons of water. Refer to
material manufacturer's instructions.
5. Once materials are mixed, release Lock Handle
and use the Front Handle to tilt Drum opening
downward and dump materials where needed. The
materials are dumped while the Drum is rotating.
note: The drum can be pivoted 360° in either direction.
6. Loosen the Bolt on the back of the Pivot Bracket
to pivot the drum. Tighten Bolt when finished.
cautiOn! Never leave the Cement Mixer running while
unattended. Do not turn Mixer off while full of cement.
7. When finished, press the red "OFF" (O) Button,
the Drum will stop. Disconnect the Power Cord.
8. Tilt the Drum angle as far down as
possible to drain all fluids from Drum.
9. Clean, then store out of children's reach.
Page 11