Table of Contents
Advertisement
DMS-3130 Series Layer 3 Stackable Managed Switch Hardware Installation Guide
Use only approved power cable(s). If you have not been provided with a power cable for your system or for
•
any AC-powered option intended for your system, purchase a power cable that is approved for use in your
country. The power cable must be rated for the product and for the voltage and current marked on the
product's electrical ratings label. The voltage and current rating of the cable should be greater than the ratings
marked on the product.
To help prevent electric shock, plug the system and peripheral power cables into properly grounded electrical
•
outlets. These cables are equipped with three-prong plugs to help ensure proper grounding. Do not use
adapter plugs or remove the grounding prong from a cable. If using an extension cable is necessary, use a 3-
wire cable with properly grounded plugs.
Observe the extension cable and power strip ratings. Make sure that the total ampere rating of all products
•
plugged into the extension cable or power strip does not exceed 80 percent of the ampere ratings limit for the
extension cable or power strip.
To help protect the system from sudden, transient increases and decreases in electrical power, use a surge
•
suppressor, line conditioner, or uninterruptible power supply (UPS).
Position system cables and power cables carefully. Route cables so that they cannot be stepped on or tripped
•
over. Be sure that nothing rests on any cables.
•
Do not modify power cables or plugs. Consult a licensed electrician or your power company for site
modifications. Always follow your local or national wiring rules.
When connecting or disconnecting power to and from hot-pluggable power supplies, observe the following guidelines:
Install the power supply before connecting the power cable to the power supply.
•
Unplug the power cable before removing the power supply.
•
If the system has multiple sources of power, disconnect power from the system by unplugging all power
•
cables from the power supplies.
Move products with care and ensure that all casters and stabilizers are firmly connected to the system. Avoid
•
sudden stops and uneven surfaces.
This equipment is only to be connected to PoE networks without routing to outside plants.
•
To help avoid damage to the system, be sure that the voltage selection switch, on the power supply, is set to match
the power available at the Switch's location:
115V/60Hz is used mostly in North and South America as well as Far Eastern countries like as South Korea
•
and Taiwan
100V/50Hz is used mostly in Eastern Japan and 100V/60Hz in Western Japan
•
230V/50Hz is used mostly in Europe, the Middle East, Africa and the Far East
•
CAUTION: Risk of Explosion if Battery is replaced by an Incorrect Type. Dispose of Used Batteries
According to the Instructions.
ATTENTION: Risque d'explosion si la batterie est remplacée par un type incorrect. Jetez les piles
usagées selon les instructions.
警告：如果更換不正確之電池型式會有爆炸的風險。請依製造商說明書處理用過之電池。
CAUTION: Shock hazard
This product is intended to be use with a UL Listed Optical Transceiver product, Rated DC3.3V,
Laser Class I.
ATTENTION: Risque d'électrocution
Ce produit est destiné à être utilisé avec un produit émetteur-récepteur optique répertorié UL, évalué
DC3.3V, classe laser I.
Consignes de sécurité
Veuillez prêter une attention particulière aux consignes de sécurité suivantes pour assurer votre sécurité personnelle
et protéger votre système des dommages potentiels.
v
Advertisement
Table of Contents
