Table of Contents
Advertisement
DMS-3130 Series Layer 3 Stackable Managed Switch Hardware Installation Guide
LED
Console
MGMT
RPS
Fan Error
USB
Link/Act/Speed LEDs
Figure 2-2 LED indicators for the DMS-3130-30TS
Description
This LED will light solid green after the Switch has been powered on successfully.
This LED will be off when the Switch is no longer receiving power (i.e. powered
off).
This LED will light solid green when the console port is active.
This LED will be off when the console port is not active.
The Left LED indicates the status of MGMT port.
This LED will light solid green (1000 Mbps) or amber (10/100Mbps) after a link to
the MGMT port was successfully established.
This LED will blink when activity on this port is taking place.
This LED will be off when MGMT port is not active.
The Right LED indicates the status of receiving power from a PSE.
The LED will light solid green when it is receiving power from a PSE.
The LED will light solid amber when power supply is in an error state.
The LED is off when there is no PSE connected to the port.
This LED will light green when the Redundant Powers Supply is in use.
This LED will be off when the RPS is not in use.
This LED will light solid red when the fan fails.
This LED will be off when the fan is operating normally.
This LED will light solid green if a USB flash drive is plugged in.
This LED will blink green when the Switch is reading or writing data to and from
the USB drive.
This LED will be off when no USB drive is plugged into the USB port.
The Switch has LED indicators for Link and Activity.
2.5G RJ45 Ports (No.1~24): The LED at the left side indicates the Link/Act/Speed
status of 2.5G RJ45 ports. This LED will light solid green when there is a
connection (or link) to a 2.5 Gbps Ethernet device or solid amber when there is a
connection (or link) to a 100/1000 Mbps Ethernet device on any of the RJ45 ports.
The LED will blink green when a 2.5 Gbps port is active or blink amber when a
100/1000 Mbps port is active. The LED will be off when there is no link or activity.
The LED at the right side has no LED notification.
10G RJ45 Ports (No. 25~26): The left LED will light solid green when there is a
connection (or link) to a 2.5/5/10 Gbps Ethernet device; the right LED will light
solid amber when there is a connection (or link) to a 100/1000 Mbps Ethernet
device on any of the RJ45 ports. The left LED will blink green when a 2.5/5/10
Gbps port is active; the right LED will blink amber when a 100/1000 Mbps port is
active. The LED will be off when there is no link or activity.
SFP28 Ports (No. 27~30): The triangle LED indicates the Link/Act/Speed status
of 25G SFP28 ports. This LED will light solid green when there is a connection (or
link) to a 25 Gbps Ethernet device or solid amber when there is a connection (or
link) to a 10 Gbps Ethernet device on any of the SFP28 ports. The LED will blink
15
Advertisement
Table of Contents
