Advertisement
REAR PANEL GUIDE
A - Balanced Output - XLR:
Female three-pin XLR: pin-1 is ground, pin-2 is high (+), and
pin-3 is low (-).
B - Balanced 1/4" TRS Line In:
Line Input mode connector. Bypasses the mic preamp gain
stage to accommodate line-level signals. Depress the
INSERT switch (ref. #1) to utilize this Line Input mode input.
C - Balanced 1/4" TRS Line Out:
Direct output of preamp gain stage before EQ and Output
Level control. Note: this output always outputs a signal,
whether or not the INSERT is engaged. This allows for an
optional dry signal recording as well.
D - Balanced Input - XLR:
Mic Input mode connector. Male three-pin XLR: pin-1 is ground,
pin-2 is high (+), and pin-3 is low (-).
Note: Balanced 1/4" TRS is tip high, ring low, sleeve ground
INSERT/LINE INPUT MODE
Line Input mode bypasses the mic preamp stage to accommodate
line-level signals. Depressing the Insert switch bypasses the first
gain stage and routes the signal from the Line Input connector
straight to the optional CurveShaper™ circuitry and Output Level
control (ref. #5). The illuminated green LED below the Insert switch
indicates when the insert is active. Plug line level signal sources
into the Line In connector (ref. B) located on the back panel.
⬆
⬆ ⬆
A
B
10
⬆
C
D
Advertisement
