Siemens SIMATIC NET SCALANCE W734-1 Operating Instructions Manual page 23

Industrial wireless lan
Hide thumbs Also See for SIMATIC NET SCALANCE W734-1:
Table of Contents

Advertisement

LED
R1
F
P1
P2
R1
Note
Primary user (radar) on all enabled channels
If the device detects a primary user (for example radar signals) on all enabled channels of the
WLAN interface, the LED F is lit and R1 flashes. No data traffic is then possible for the next
30 minutes. After this time, the device runs the scan again and checks whether a primary user
still exists. If no primary user is detected, data traffic is possible again.
The wait time of 30 minutes is necessary due to legal requirements and cannot be shortened
even by restarting the device.
SCALANCE W774-1 /W734-1
Operating Instructions, 09/2017, C79000-G8976-C325-09
Color
Meaning
SCALANCE W774 in access point mode:
Green
The WLAN interface is initialized and ready for operation.
SCALANCE W774 in client mode or SCALANCE W734:
There is a connection via the WLAN interface.
Green and yel‐
Data transfer over the WLAN interface.
low flashing alter‐
nately
SCALANCE W774 in access point mode:
Green
flashing briefly
With 802.11h, the channel is scanned for one minute for primary users
before the channel can be used for data traffic.
SCALANCE W774 in client mode or SCALANCE W734:
The client waits for the MAC address due to the setting "Automatic" for the
"MAC mode" parameter and is connected to no access point.
Green
SCALANCE W774 in client mode or SCALANCE W734:
flashing 3 x
The client waits for the MAC address due to the setting "Automatic" for the
short, 1 x long
"MAC mode" parameter and is connected to an access point.
Red
An error occurred during operation with the device.
Red
A primary user was found on all enabled channels.
R1 flashing yel‐
low at the same
time
Red:
An upgrade/downgrade of the firmware is installed from the plug:
Flashes at the in‐
Afterwards the device is restarted and the device configuration incl. users
terval: 2 sec. on /
and certificates stored on the PRESET-PLUG is transferred to the device.
0.2 sec. off
Flashing yellow
"Flashing" enabled using SIMATIC NET Primary Setup Tool (PST).
Description of the device
3.5 LED display
23

Advertisement

Table of Contents
loading

This manual is also suitable for:

Simatic net scalance w774-1

Table of Contents