Table of Contents
Advertisement
Adjusting your monitor image
This section describes the user control features used to adjust your monitor image.
Using the direct access controls
The direct access controls can be used when the On Screen Display (OSD) is not displayed.
Icon
Note:
• When Brightness adjustment bar is displayed on screen, use + or - for adjustment.
• When Contrast adjustment bar is displayed on screen, use + or - for adjustments.
• Low Blue Light Mode is reducing the blue light content.
• The use of Extreme Mode (response time) may result in reduced display quality when fast
moving video graphics are displayed. Users should check Extreme Mode (response time)
to verify if it is compatible with any applications they would like to use it with.
Energy Star is an energy saving program for consumer electronics led by the U.S.
government. It was launched in 1992 by EPA and DOE to reduce energy consumption
and greenhouse gas emissions. Energy Star logo is a symbol of energy conservation and
environmental protection. It improves the concept of energy efficiency of consumers and
manufacturers, and effectively guides the market.
The regulation of Energy Star improves energy efficiency and reduces air pollution by using
more energy-efficient equipment in homes, offices and factories. One way to achieve this
goal is to use management to reduce energy consumption when products are not in use. The
default settings for monitors conform to Energy Star certification. Any changes by users for
more features and functionalities may increase power consumption, which will exceed the
limitation of Energy Star's standard. For more information, please refer to (www.energystar.
gov/products). All products of Energy Star will be posted online and can be accessed
directly by governments, public institutions and consumers.
2-4 M15 Flat Panel Monitor User's Guide
Table 2-1. Direct access controls
Control
Brightness
Contrast
Low blue light
Over drive
Description
Press + or - key for Brightness adjustment.
Press and hold + key over 3 seconds for Contrast adjustment.
Press to enable / disable Low Blue Light.
Press and hold for 3 seconds to enable/disable the Overdrive.
Advertisement
Table of Contents
