Table of Contents
Advertisement
HYAG900E Grinding Disc Assembly
Warning! When mounting discs, ensure the machine is turned off,
!
and unplugged from the power source.
Warning! Before install Grinding Disc's, ensure the Disc Guard (K) is
!
attached to the machine
1.
On to the Spindle, firstly place the Internal Flange Nut (I). This will
just slide on. Ensure it locks into the spindle.
2.
Then place your Grinding disc. Ensure the disc is sitting flat against
the Internal Flange Nut (I)
3.
Now holding the Spindle Lock button (B), screw on the External
Flange nut (H). Ensure the flange on the nut sits inside the inner
diameter of the Grinding Disc. Tighten this as much by hand as
possible.
4.
Use the Flange spanner (J) to fully tighten the Exterior Flange nut.
Place the tabs of the Flange spanner into 2 opposing holes on the
External Flange nut (H).
Assembly
N
M
J
www.hyundaipowerproducts.co.uk
www.hyundaipowerproducts.co.uk
I
H
18
Advertisement
Table of Contents
